T30 ELECTRICIANS PULLER RODS WIRES
Operation:
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
|
T2 quick tight with wire steel rope |
1.Made of steel wire rope 2.Density: 8(g/m) 3.Rod diameter 2(mm) 4.Temperature - 800 to 800 (℃) 5.Traction tension failure 800(kg) |
|
|
BS-30 FOB cable duct rod |
Features: 1) Strong non-conductive fiberglass rod construction. 2) Rustproof bull-nose pulling eye. 3) For longer conduit runs and underground duct... |
|
|
independent producer movable rodder |
Fiberglass duct rodder is an auxiliary tool applied in towing lead-rope through a pipe. The rod surface is hard and smooth, so it can get through t... |
|
|
DPHC03 Bridge Roller |
It can be used in single one,aslo can be used in series.Straight cable rollers shall be placed in the cable trench to prevent the LV-HV cable from ... |
|
|
BF-15 non-store seling duct rodder |
The unique sloped handle optimizes the position of your hand for quick hand-over-hand rewinds and allows a more level payout of tape on the backswi... |
All supplier products
Same products