T2 good for sewer duct rodder/ quick pulling
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
CBRL insulating rodder |
High Density polyethylene (Grade: for the insulating and jacketing of Telecommunication Cables) is used in the outer diameter coating.Duct Rodders ... |
|
TC-38 Hand handle types of Tool |
Features: 1.Strong, light weight glass fiber handle. 2.Adjustable pivot bolt realized adjustable blade. 3.Changeable, forging blade heat treated an... |
|
JT-300 integral mechanical crimping pliers |
Manual type crimping pliers:Using high and low two levels of plunger pump driven design, operation fast and effort; System is equipped with safety ... |
|
DNP duct rodder |
Feed device allows rod to feed out or be back with easy push or pull of rod Rugged tubular steel reel with adjustable positioning Rustproof bull-no... |
|
BF-15 high quality duct rodder |
Features: 1) Strong non-conductive fiberglass rod construction. 2) Rustproof bull-nose pulling eye. 3) For longer conduit runs and underground duct... |
All supplier products
Same products