T50 fish type kit
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
|
L06S30 Customized push pull rodder |
Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe line... |
|
|
SJKL-4 300-400 square cable grip, insulated wire grip |
Wire clamping device is the power, telecommunications, railway electrification overhead line construction and maintenance of the commonly used to h... |
|
|
Cable rollers linear DPHC03 |
It can be used in single one,aslo can be used in series.Straight cable rollers shall be placed in the cable trench to prevent the LV-HV cable from ... |
|
|
T30 best quality cable tight |
1.Black spring and red glue to the above 2.Wire rope twists the figure 8 3.Wire wear into the figure 8, spring lock wire 4.Wire put into red rubber... |
|
|
Coaxial Cable cora duct rodder |
Constructed of fiberglass reinforced in the center and consists of a rugged plastic layer that would ensure the lifetime of the flexible rod. Assem... |
All supplier products
Same products