T2 quick cable tight , storage box
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
BF-60 Customized frp push pull rodder |
A mechanical puller will severely damage the tape, and could lead to personal injury. Use a safe work position to avoid loss of balance when using ... |
|
Wire Cable Running Rod |
with lighter weight and good quality, it is the best tools for electric power construction wiring. By testing, it could be through 4 corners easily... |
|
CONNER CABLE ROLLER |
Electrical cable roller is a equipment for laying,pulling,guiding and protecting cable/rope/wire,which is a great way to save time and money. It is... |
|
HZ-65C/85C/105C Hydraulic Cu/Al cable Cutter |
HZ-65C/85C/105C armoured Cu/Alu cable cutter 1. Simple and convenient-opening C type cutting head 2.Double hydraulic stages alternately ensure the ... |
|
W0850T fish type obdurability |
then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold... |
All supplier products
Same products