L06S50 Tracing Duct Rod
then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
4.5mm x 50' Duct Rodder Fish Tape |
Adopt imported special plastic steel, firm with soft, durable wear resistant Bullet + roller head double lead, cornering ability strong, easy to us... |
|
|
Hydraulic Cable Drum Jacks, Cable Jack Stand |
Application: for general outdoor underground cable Actinobacillus operation, high-altitude stringing House switchboard construction wiring. Operati... |
|
|
Indoor type of duct rodder |
Outer protect layer are made of high density polyethylene engineering plastic, which has good anti-UV capability. Cover was coated with long-term U... |
|
|
TC-125S telescopic hand cable cutter |
TC-125S cable cutter with telescopic handle,is forged, long life span and easy to cut. Feature: With telescopic handle. Attention:do not cut steel ... |
|
|
LOPG-1 OPGW cable grip pliers |
Card line due to the use of different conditions, different varieties and specifications of the grip the wire, divided into: Aluminum Wire Card thr... |
All supplier products
Same products
