T2 cable puller accessories
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
HZ-65C/85C/105C Hydraulic cable Cutter |
HZ-65C/85C/105C armoured Cu/Alu cable cutter 1. Simple and convenient-opening C type cutting head 2.Double hydraulic stages alternately ensure the ... |
|
W0850T electric cable puller |
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secon... |
|
SKDD-2 wire grip |
Wire clamping device is the power, telecommunications, railway electrification overhead line construction and maintenance of the commonly used to h... |
|
portable shelves duct rod |
High Density polyethylene (Grade: for the insulating and jacketing of Telecommunication Cables) is used in the outer diameter coating.Duct Rodders ... |
|
AS-15 sewer insulating rodder |
Features: 1) Strong non-conductive fiberglass rod construction. 2) Rustproof bull-nose pulling eye. 3) For longer conduit runs and underground duct... |
All supplier products
Same products