T2 cable access kit push pull rod cable puller duct rodder
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
|
T2 cable access kit push pull rod cable puller duct rodder |
1.Black spring and red glue to the above 2.Wire rope twists the figure 8 3.Wire wear into the figure 8, spring lock wire 4.Wire put into red rubber... |
|
|
duct rodder provider |
There are meter marks on the protect layer of duct rodder, which can be used for measuring distance. Marks are printed by professional printing mac... |
|
|
SD-1000C Multi function wire grip |
Directions for manufacturer, whole saleand retail for all kinds of grips.TheCable Grip/clampsare widely used in power cable and communication line ... |
|
|
W0850T fish type obdurability |
then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold... |
|
|
HT131LN-C integral manual hydraulic clamp |
Hydraulic crimping pliers:Monolithic crimping pliers, crimping pliers need to separate with the corresponding pump, general suitable for electric o... |
All supplier products
Same products