T2 quick cable tight , storage box
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
|
SKDD-1 single-cam wire grip,steel strand cable grip |
Wire clamping device is the power, telecommunications, railway electrification overhead line construction and maintenance of the commonly used to h... |
|
|
Indoor type eco duct rodder |
A braided wrap of reinforcing fibers increases its rigidity and helps bond the core with the outer plastic coating. The coating is made from a poly... |
|
|
HZ-85 Hydraulic Cable Cutters with safety valve inside |
1. Flip top cutting head rotates 350o 2.Two stage hydraulic to reduce cutting cycle, automatic release pressure when cut is completly stop 3. Manua... |
|
|
DNP movable rodder |
Constructed of fiberglass reinforced in the center and consists of a rugged plastic layer that would ensure the lifetime of the flexible rod. Assem... |
|
|
BF-60 wholesale duct rodder |
A mechanical puller will severely damage the tape, and could lead to personal injury. Use a safe work position to avoid loss of balance when using ... |
All supplier products
Same products