split wire mesh grip
Open weave hoisting grips provide an effective means for hoisting coax and elliptical waveguide into position and can be utilized to provide additional support once in place. The lace-up design allows the hoisting grip to be attached even when the run has been connectorized and facilitates easy positioning at 200 (61m) increments on long coax runs.
Closed weave hoisting grips feature a closed-mesh design which simplifies installation over traditional split, lace-up style grips. The unique design allows the pre-laced hoisting grip to slip over an unterminated end of coax. The grip securely tightens when pulled, providing an effective means to hoist coax into position and to provide additional support for the coax once in place.
Other supplier products
|
|
SKG-50N anti-twist rope wire grip |
Application: apply for anti-twist rope
Rated Load(KN)
Wire rope Diameter(mm)
Weight(Kg)
SKG-50N
50
11-15
7
SKG-70N
70
16... |
|
|
Towing Smooth wire mesh grip protecting |
Cable Socks / cable pulling grip mainly used for all kinds of wire and cable (overhead conductors, insulated cables, etc.) of tractor pay-off const... |
|
|
Cable roller DPHC01 |
The cable roller can protect the cable, at the same time, cable block also can effectively reduce the friction of the cable, improve the constructi... |
|
|
Cable Pulling Snake push pull rod duct rod |
Features Constructed of fiberglass reinforced in the center and consists of a rugged plastic layer that would ensure the lifetime of the flexible r... |
|
|
CBRL insulating rodder |
Brand-New High Quality FibreGlass Duct Rodders or Snake Pullers can be used for NBN, Telecommunication, Electrician and other Department HDPE Pipe ... |
All supplier products
Same products
