cable pulling socks
Pulling grips Styles and Applications
1.Medium duty pulling grips are double weave for added strength with greater mesh contact on the cable to handle longer or heavier pulling jobs.
2.light duty pulling grips are single weave with a flexible eye for easy attachment to a pulling line. Cable Pulling Grips are used in general underground electrical construction where pulling tensions are low.
3.slack pulling grips are made of galvanized steel and come in three styles with a single offset eye for easy attachment to a pulling line. cable socks Closed, when the cable end is accessible, split lace and rod closing when cable end is not accessible. Cable grip are used in pulling slack for final placement of underground cable after Cable Pulling Grips has been pulled and longer mesh for higher pulling loads where space is not restricted.
Other supplier products
|
|
fiberglass conduit rod reel |
High Density polyethylene (Grade: for the insulating and jacketing of Telecommunication Cables) is used in the outer diameter coating.Duct Rodders ... |
|
|
DNP eco duct rodder |
Features Constructed of fiberglass reinforced in the center and consists of a rugged plastic layer that would ensure the lifetime of the flexible r... |
|
|
rodder with cable kit |
Features Constructed of fiberglass reinforced in the center and consists of a rugged plastic layer that would ensure the lifetime of the flexible r... |
|
|
cable drum jacks |
Cable jacks according to usage is also referred to as the cable bracket, wire shaft disc rack, cable bracket. The form can be divided into, hydraul... |
|
|
Corner roller |
Cable block is generally used in the ground and cable bridge frame protection of high voltage cable. The cable roller can protection 180 mm diamete... |
All supplier products
Same products
