EK60VP-L charging crimping EK60VP-L charging crimping pliers from KLAUKE Germanpliers from KLAUKE German
Operation process
1 Take the product from the packaging,at the same time, take out the required die in die card buckle.
2 Equipped with batteries and the terminal into the mould then press the switch to pressure; Pending after pressure to the piston will retract automatically, then loosen the switch can be reset, process is finished.
Other supplier products
|
supply New L06S20 PLASTIC STEEL rods, electric cable duct rod |
This kind of imported steel wire material, make the line more straight and full of elasticity, into a tube and shell, not blocked or bend down, in ... |
|
belt drive or shaft drive, cable winch |
The use of ground grinding security technology (1) the ground should be put on the flat, accessibility, and fixed tightly, prevent the ground plan... |
|
Cable pulling Grips |
mainly used for all kinds of wire and cable (overhead conductors, insulated cables, etc.) of tractor pay-off construction, is the electric power (o... |
|
BS-15 conduit Tracing Duct Rod |
The unique sloped handle optimizes the position of your hand for quick hand-over-hand rewinds and allows a more level payout of tape on the backswi... |
|
S-3000CL 3T all purpose wire pliers |
Wire clamping device is the power, telecommunications, railway electrification overhead line construction and maintenance of the commonly used to h... |
All supplier products
Same products