HEC-240 the charging cable crimping pliers
Operation process
1 Take the product from the packaging,at the same time, take out the required die in die card buckle.
2 Equipped with batteries and the terminal into the mould then press the switch to pressure; Pending after pressure to the piston will retract automatically, then loosen the switch can be reset, process is finished.
Other supplier products
|
|
preformed dead end grip for cables |
Cable Socks / cable pulling grip mainly used for all kinds of wire and cable (overhead conductors, insulated cables, etc.) of tractor pay-off const... |
|
|
FLEXI LEADER FOR FIBREGLASS RODDER |
This product adopts import international advanced technology formula spring steel plastic materials, high strength, high elasticity, high toughness... |
|
|
BF-45 duct rodder producer |
Note: keep one hand holding the interior wall of Wire device while use it, and the other hand holding the handle of wire device, rotating clockwise... |
|
|
HZ-65C/85C/105C armoured Cu/Alu cable cutter |
FEATURES HZ-65C/85C/105C armoured Cu/Alu cable cutter 1.Simple and convenient-opening C type cutting head 2.Double hydraulic stages alternately ens... |
|
|
DRUMS ROLLERS AND JACKS Cable Drum Screw Jacks |
Cable reel stand is a compact solution for spooling heavy drums of power and data cable or conveyor belts. The system comprises of two independent ... |
All supplier products
Same products