EP-510BH separate hydraulic crimping pliers
Hydraulic crimping pliers needing attention：
1 manual ratchet crimping pliers use and maintenance of the matters needing attention
2 don't charged line pressing, or in the vicinity of a charged conductor operations, can appear to avoid electrical shock.
3 crimping terminal crimping pliers pressure with the use of forceps must form a complete set. Terminal size and crimping pliers don't fit, there will be pressure to the phenomenon of insufficient or excessive pressure, and could lead to damaged crimping pliers and fault.
4 the crimping pliers handle not pressing ratchet mechanism doesn't work. Die on front end department shall be confirmed after the ratchet release.
5 crimping pliers for precision tools, shall not do him, not rough operation.
6 according to the frequency of daily use, crimping pliers, pin, shaft and bearing contact surfaces should be timely daub lubricating oil; Crimping pliers when not in use, its income tool box and storing clean, dry place.
7 when using the surface pressure molding department not to rust, damage and dirt. Crimping pliers, if in the case of die residual metal debris still use it, may result in incomplete or pressure to failure.
8 used for regular inspection tools, especially the ratchet machinery (pressure limiting device), etc., shall not continue to use in a loose situation.
Other supplier products
|
|
CPC-100B split cable cutting head |
Features: Split hydraulic cable cutter can work with hydraulic hand pump or electric hydraulic pump, it is suit for big size of tele cables or armo... |
|
|
CRS power tools Hydraulic Cable Drum Stand |
Application: for general outdoor underground cable Actinobacillus operation, high-altitude stringing House switchboard construction wiring. Operati... |
|
|
stringing tools-cable winch |
3T AND 5T Petrol Engine Powered Winches This engine winch is used to work for tower assembly or moving heavy and bulky materials when stringing wor... |
|
|
BS-15 movable rodder Vendor |
Features: 1) Strong non-conductive fiberglass rod construction. 2) Rustproof bull-nose pulling eye. 3) For longer conduit runs and underground duct... |
|
|
7/8" stainless steel wire mesh grips |
Cable Socks / cable pulling grip mainly used for all kinds of wire and cable (overhead conductors, insulated cables, etc.) of tractor pay-off const... |
All supplier products
Same products
