CJX2 Contactor
Scope of Application
CJX2 Contactor is mainly used for the circuit of AC 50Hz (or 60Hz), the voltage to 660V, the rated operating current to 95A in the utilization category of AC-3, 400V (380V), for the remote on and off circuit, frequent start and control AC motor, and combine with the appropriate thermal relay to form electromagnetic starter to protect the circuit may occur overload operation.
Normal operating conditions and installation conditions
1. Ambient air temperature: -5℃~+40℃, the average does not exceed +35℃ within 24 hours.
2. Altitude: not more than 2000m.
3. Atmospheric conditions: the maximum temperature is +40℃, the relative humidity is not more than 50%; at lower temperatures can allow a higher relative humidity, for example, +20℃ up to 90%, special measures should be taken for condensation produced occasionally due to temperature changes.
4. Pollution level: 3.
5. Installation category: Ⅲ.
6. Installation conditions: The inclination of the installation surface and the vertical plane is not more than ±5°.
7. Shock Vibration: The product should be installed and used in the place without significant shaking, shock and vibration.
8. Installation method: Except for screw installation, but also 35mm standard card rail installation. AC operation 40-95 can installed in 35mm or 75mm card rail.
Other supplier products
|
|
WCT Din Rail Mounted Contactor |
Scope of Application WCT Din Rail Mounted Contactor (also called CT contactor, household Contactor), mainly used in power system of AC 50Hz/60Hz, r... |
|
|
DW45 Air Circuit Breaker |
Scope of applicationDW45 Air Circuit Breaker, ACB (hereinafter referred to as circuit breaker) is suitable for distribution network with AC 50Hz, r... |
|
|
DZ47S-63 Circuit Breaker |
Scope of Application DZ47S-63 Miniature Circuit Breaker with shunt trip is suitable for AC 50Hz (or 60Hz), rated voltage 230 / 400V, rated current ... |
|
|
SVC Voltage Stabilizer |
Product Overview SVC Voltage Stabilizer (TND Single Phase Voltage Stabilizer, TNS three phase voltage stabilizer) is composed of contact regulator ... |
|
|
TNID Residual Current Circuit Breaker |
Scope of ApplicationTNID-63 Residual Current Circuit Breaker is used for the circuit of AC 50Hz, rated voltage of 230V for 2 poles, 400V for 4 pole... |
All supplier products
Same products
