CRGO edge chamfer wound cores for transformer

• 
• 
• 
• 
• 
• 
• 
• 

CRGO Tape wound Cores
wind one long continuous silicon steel tape tightly into a spiral
advantage: no air gap, high magnetic properties, easy to roll
weakness: difficult to wind large cores and realize mechanized

Welding ：Spot welding is firm and smooth, and does not weld through two layers
Winding ：winding is tight, the start and end of the sheet can not be turned up
Planeness ：surface unevenness is less than 0.1mm
Fineness ：No crystalline fine particles (no crystalline fine particles on the cut surface)
Cut face ：No obvious crack on the cutting face (no light transmission and peeling between layers)
Surface ：Visually without burrs, rust, or deformation (to control deformation within tolerances)
Products ：Do not contain PbCdHgCrPBBsPBDEs

Other supplier products

	CRGO tape wound toroidal cores for transformer	Toroidal Core Low noise The core of toroidal transformer has no air gap, so there will be less induced shaking noise. And copper wires embrace the ...
	silicon steel three-phase E typed cores for Transformer	different types of silicon steel / electrical steel / CRGO / CRNGO Magnetic tape wound cores for transformer sensor etc. Material Property:CRGO&...
	mini size tape wound toroidal cores for closed loop hall effect current sensor	different types of silicon steel / electrical steel / CRGO / CRNGO Magnetic tape wound cores for transformer sensor etc.Material Property:CRGO&a...
	silicon steel winding toroidal cut cores for sensor	different types of silicon steel / electrical steel / CRGO / CRNGO Magnetic tape wound cores for transformer sensor etc. Material Property:CRGO&...
	electrical steel lamination Block cores for transformer	different types of silicon steel / electrical steel / CRGO / CRNGO Magnetic tape wound cores for transformer sensor etc. Material Property:CRGO&...

Same products

	Type A-I Series Subracks	Seller: Beijing Rdekono Electronic Equipment Co.,Ltd	The subrack is used as a desktop case The subrack is equipped with VC legs to prevent the chassi...
	19"CUR Series Subracks	Seller: Beijing Rdekono Electronic Equipment Co.,Ltd	Definition of a 19"system: The width dimension of the outer side of the installation flange is 48...
	EG PRO Series Subracks	Seller: Beijing Rdekono Electronic Equipment Co.,Ltd	The current models of the EG series chassis are divided into: Chassis height: 3U chassis, 4U cha...
	Custom Enclosure	Seller: Beijing Rdekono Electronic Equipment Co.,Ltd	Custom Enclosure Introducing Rdekono: Your Partner for Cutting-Edge Custom Rack Mount Enclosures...
	Standardized Subrack	Seller: Beijing Rdekono Electronic Equipment Co.,Ltd	Introducing Rdekono: A Leading Networking Rack and 19-Inch Subrack Manufacturer Are you in searc...