Metal Sheet Cut To Length Line
Main specification for Metal Sheet Cut To Length Line: Cut to length
● Raw material width: maximum 1250mm
● Thickness of raw material: 0.2-2.0mm
● Working speed:10-15m/min
● Transmission: Three group rubber rollers
● Diameter of rubber roller:110mm
● Material of leveling rollers: Gcr15 bearing steel,Website:, quenched 55-58
● Main power: 3kw
● Hydraulic cutting: 3kw
● Electrical control system: PLC Panasonic Japan. 380V, 50HZ (according to your requirement)5 tons hydraulic decoiler
● Single arm to put the coil
● Expanding Range: Φ460～Φ520mm
● Capacity:5 Ton
● Max width for coil: 1300mm
● Power of hydraulic station: 3KW
● The motor power : 5.5KW
● Hydraulic pressure: 16Mpa
● Material of shaft: Gcr45 steel
● Size of decoiler: About (H*L*W)1.8M*2.5M*1.2M
● Weight of equipment: About 3TonWorking flow for Metal Sheet Cut To Length Line: Decoiler--guiding--transmission--leveling--transmission--output tablePhotos for Metal Sheet Cut To Length Line: Company Testimonial Exhibition After sales service:
1).Engineer will give free training lessons to labors in buyer’s factory.
2).The Buyer will buy the round-trip air ticket for Engineer if visa application is approved.
3).The buyer is also responsible to bear expenses generated, e.g. visa formalities, meals, accommodation and allowance of USD80 for engineer per day.
4).During this guarantee period, we will provide spare parts without any charge in case of quality discrepancy caused by us. If the malfunctions are caused by your incorrect operations, we will provide the buyer spare parts at cost price.
5).We will charge the buyer cost price of spare parts beyond one year and provide long-term technical guide.
Other supplier products
|
|
T Bar Angle Roll Forming Machine |
Working flow: Decoiler--feeding--punching--roll forming--cut to length--output table Equipment list for T bar angle roll forming machine: Main spec... |
|
|
Steel Beam Roll Forming Machine |
The profile drawing of steel beam roll forming machineThe thickness of Material: 1.5-2.5mm Working flow of steel beam roll forming machine: uncoile... |
|
|
Shelf Making Machine |
The profile drawing of shelf making machineThe thickness of Material: 1.5-2.5mm Working flow: uncoiler—Leveling—Punching--roll forming--- hydraulic... |
|
|
Roll Formers |
Main specification for Roll Formers: A. Manual uncoiler
1) Capacity: 5ton
2) Feeding width: MAX 1300mm
3) Expanding range: 480-520... |
|
|
Hydraulic Uncoiler |
Main specification of the hydraulic uncoiler: 1) Capacity: 15 tons 2) Expanding Range: Φ460～Φ610mm,Website:, namely 18-24 inch. 3) size for co... |
All supplier products
Same products
