3A PWM Solar Panel Charge Controller 12V/24V Battery Regulator
Pulse Width Modulation (PWM) is the most effective means to achieve constant voltage battery charging by adjusting the duty ratio of the switches ( MOSFET ). In PWM charge controller, the current from the solar panel tapers according to the battery’s condition and recharging needs. When a battery voltage reaches the regulation set point, the PWM algorithm slowly reduces the charging current to avoid heating and gassing of the battery, yet the charging continues to return the maximum amount of energy to the battery in the shortest time.
Features
1. High quality, reliable and economically priced charge controller
2. PWM charge controller is a good low-cost solution for small systems
3. Automatic 12/24v depends on battery voltage.
4. Overcharge and over discharge protection for the battery.
5. 3-stage charging algorithm, impulsive charge, bulk charge, floating charge
Specification
Nominal output(automatic identification): 12V/24V
Operating current: 3A
Short-term load current (60 seconds): 6A
MAX Solar panel: 40W/80W
Over-discharge protection: 10.8V/21.6V
Overcharge protection: 14.4V/28.8V
Float charge: 13.8V/27.6V
PWM charging: YES
Self-Consumption: 1.5mA/3mA
Waterproof Class: IP22
Application
This solar charge controller is perfect for 10W-25W solar panel system.
Installation
1. Connect the battery positive and negative to the controller.
2. Positive and negative load wires to the controller, pay attention to cannot be reversed.
3. Connect the solar panel to the controller correctly.
4. Please follow the above sequence in strict order, otherwise, it may damage the controller. The disassembly order is the opposite of the wiring sequence.
Send product request
Other supplier products
 |
10 Watts 12 Volts Epoxy Solar Panel Module for Car RV Battery Charging | The Eco-sources series of the 10W epoxy solar panelhas been traditionally used for solar lights, solar toys, solar educational kits for kids and st... |
 |
12V 50Ah Sealed Lead Acid Deep Cycle Battery | 12V 50AH Sealed lead acid batteryis one kind of updated maintenance-free battery with a valve-regulated structure for installing solar power. It ca... |
 |
100W 12V Bendable Lightweight Thin Monocrystalline Flexible Solar Panel | The Eco-Sources 100 Watt 12 Volt monocrystalline lightweight flexible solar paneluses advanced monocrystalline cells that have been laminated into ... |
 |
100W Polycrystalline Solar Panel for RV’s, Boats and 12V Systems | Thesepolycrystallinesolar panelscompose of high-efficiency solar cells (approximately 17.4%) with quality silicon material for high module conversi... |
 |
100W 12V Off-Grid Monocrystalline Portable Folding Solar Panel Suitcase | This 100Wfoldable solar panelis made up of monocrystalline solar cells, which give you one of the most efficiency per space. It’s a suitcase-... |
Same products
 |
Made in China temperature controller WK-P2T(TH) for thermal power plant | Seller: DONGFANG YOYIK (DEYANG) ENGNIEERING CO; LTD | "Made in China temperature controller WK-P2T(TH) for thermal power plant Dongfang Yoyik Engineeri... |
 |
Temperature Controller | Seller: Tinko Instrument (Suzhou) Co., Ltd. | Tinko temperature controller industrialcan improve process efficiency, product quality and minimi... |
 |
Sequence Valve Gate Controller | Seller: Tinko Instrument (Suzhou) Co., Ltd. | Tinko hydraulic valve gate controllerenables control of valve gate flow sequence and timing for p... |
 |
TSC-02 Stand Alone Controller | Seller: Tinko Instrument (Suzhou) Co., Ltd. | Tinko TSC-02 integrated dual zone temperature controlleris suitable for small mold. The portable ... |
 |
TSC-01 Stand Alone Controller | Seller: Tinko Instrument (Suzhou) Co., Ltd. | Tinko TSC-01 integrated single zone hot runner temperature controller is suitable for small mold.... |
