Full welded ball valve
Full welded ball valve
The pressure in the pine line push the seat ring moving towards ball, thus form the sealing; as the sealing is formed by the line pressure itself, the performance will be better, in the mean time, it also reduced the operation torque of the actuator; while the ball cavity pressure exceed the line pressure, the pressure difference will push the seat off the ball to release the excessive pressure to the pipe pine; when the temperature rises, it won’t cause abnormal pressure rise in the valve cavity.
The pressure can be released to zero when the valve is in full close, full open or under pipe line pressure; also, the seeper, dirt or deposit can also be eliminated by removing the drainage plug on the valve body
In case the sealing element is destroyed by eye winker in the pipe line or smashing, sealant will be used to avoid leakage; the stem is designed with two part sealing, and sealant can be injected between.
ven when the seal is burned down by fire, the metal to metal seal design will be applied to avoid spread of fire.
Body to use high quality forged steel, with welding on the mid body, formed one piece; appearance design, high strength, light in weight, smart in volume; bolts and nuts are not adopted, thus no leakage point; suitable for under ground application.
he ball is supported by upper stem and the lower trunnion; the ball axle is maintained in it’s centerline, thus is good in sealing and operation; the low friction TFE in the stem and trunnion part enables the valve to operate smoothly and simply under pressure.
The ball valve series is maintenance free, thus greatly reduced user’s cost; the bearing, seal are adopt low friction co efficiency material, no lubricate is required
Full welded ball valve
Full welded ball valve / Technical parameters
Design standard API 6D
Face to face API 6D
Flange end ANSI B16.5
Butt-welding ends ASME B16.25
Test &inspection API 6D API598
Other supplier products
|
|
Din butterfly valve |
Din butterfly valve
These series DIN butterfly valve, adopts precise elastic sealing ring and tri-eccentric multilayer metal to metal seal constr... |
|
|
Top entry ball valve |
Top entry ball valve
Integral body design, flange or butt welded preferable
Double Block and Bleed
High strength integral stem design, precis... |
|
|
3-pieces ball valve |
Working Pressure: 1000PSI
Suitable medium:Water,oil.air and some Corrosive liquid.
Temperature Range:-20~232°C~350°C
Thread type:G&middo... |
|
|
2pcs ball valve |
2PC-JV-020 H/P
DESIGN: ASME B 16.34, API 608
INSPECTION&TESTING: API 598
THREAD: ASME B 1.20.1
|
|
|
Floating ball valve |
This series floating ball valve is applicable in the pipe lines of Class150～Class600、PN16～PN100、JIS10K～JIS20K, it is used to cut of connect the med... |
All supplier products
Same products
