Flame and Radiant Test Devices
Product description:
Thermal protection performance testerused for the determination heat radiation performance of the single or multi-layer fabric in high temperature environment.
The heat radiation performance is an important performance index of flame retardant products, accurate determination of its protective properties, which it is very important to select materials, research new products and improve the processing technology.
Method A:The sample is mounted in a separate frame and exposed to a heat radiation source for a certain time. The intensity of the thermal radiation is controlled by adjusting the distance between the sample and the radiation source. After the test, the visual changes at each level of the sample were examined.
Method B:The sample is fixed to a calorimeter and exposed to a thermal radiation source. The time required for the temperature of the calorimeter to rise by 12°C and 24°C, respectively, was measured.
On the basis of these data, the heat flux rate is calculated by the difference of the heat fluxes between the transfer and the incident.
The cooling system provides a continuous flow of water fromthe inlet and outlet of the testing machine.
Technical Parameters:
Samples: textiles
Test standard: DIN EN ISO 6942
Sensors: Calorimeters
Power supply: 3 ~ 400 VAC / 12.5 kVA
Equipment Dimensions: 2000 x 800 x 1500 mm (W*D*H)
Weight: 150 kg
Other supplier products
|
|
Vacuum Ball - Disk Friction Tester |
Main Purposes of Vacuum Ball - Disk Friction Tester
The vacuum ball - disk friction tester is a device specifically used for evaluating the slidin... |
|
|
Fiber Blend Ratio Tester |
Product Introduction:
It is used to measure the resistance value with a certain density under a certain geometry, and then converts it into the sp... |
|
|
Nbs Smoke Density Chamber, ASTM E662, ISO 5659 |
Introduction
The main principle is to measure smoke density in a particular space, cable or material produced under specific conditions of combust... |
|
|
Minimum Ignition Energy (MIE) – Dust Cloud Tester |
Description：
Dust Cloud Minimum Ignition Energy Tester disperses a certain mass of dust specimen to be tested into the Hartmann tube device thro... |
|
|
Fiber Crimp Elasticity Tester |
Product Introduction:
YG362C fiber crimp elasticity meter is used for crimp degree of 1-22dtex fiber.
Crimp elasticity, crimp recovery rate index... |
All supplier products
Same products
