Tecco Netting
Tecco Netting Specification:
Materia: High tensile steel wire.
Surface treatment: Hot dipped galvanized, zinc-aluminum coated.
Zinc thickness: No less than 150 g/㎡.
Wire diameter: 3 mm, 4 mm.
Mesh type: Rhomboid hole.
Mesh size : 65 mm/ 80mm inscribed circle diameter.
Tensile strength: Minimum 1770 MPa.
Braking load of single wire: 12.5 kN.
Mesh roll width: 1–3.5 m.
Mesh roll length: 10–30 m.
Fitting : Steel anchor, claw type spike plate, soil or rock nails,clips, sewing rope, boundary rope. (The steel anchor is made
ofdeformed steel bar of 25 mm diameter)
Other supplier products
|
|
Facade Cladding Cable Rod Woven Mesh |
Facade Cladding Cable Rod Woven Mesh is made of steel wires warp and steel rod, a special stainless steel mesh. This screen is desinged for archite... |
|
|
architectural stainless steel wire mesh |
Stainless steel decorative mesh is made of steel wires warp and steel rod, a special stainless steel mesh. This screen is desinged for architectu... |
|
|
Slope Stabilisation Mesh |
High Strength Tecco Slope Stabilization System / Slope Stabilization Protective Mesh
Slope Stabilization System is made of high strength steel wir... |
|
|
High Strength Tecco Mesh For Rockfall Protection |
High Strength Tecco Mesh For Rockfall Protection
Tecco mesh is made of high tensile strength steel wire 3.0mm 4.0mm or 2.0mm, with the tensile s... |
|
|
Decorative Metal Mesh Curtain |
Metal coil curtain is also called metal coil drapery. Generally, it is made from stainless steel wire, aluminum wire, copper wire or other material... |
All supplier products
Same products
