L06S20 sewer pipe inspection tools
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Другие товары поставщика
|
AS-15 provider insulating rodder |
Note: keep one hand holding the interior wall of Wire device while use it, and the other hand holding the handle of wire device, rotating clockwise... |
|
cable puller/Cable bollard winch |
Cable winch is an essential part of the erection of the underground cable lines, vertical bars and other construction products, can be in a variety... |
|
CPC-65C/85C/105C/120C Hydraulic Wire CableCutting Head |
CPC-65C/85C/105C/120C Hydraulic Wire Cable Cutting Head 1.Opening C type cutting head 2.Hydraulic quick couper connect with the pump for working 3.... |
|
TC-500 made in china hand tools |
TC-500 Max 500mm2 Hand Manual Cu/Al conductor Cable Wire Cutter The handle is made of high tensive aluminum alloy, the knives are made by forging, ... |
|
cable stand with jacks as power |
Features It is applicable to be as the support of large cable reel in laying cables in the city. It is easy to move with the trundles in the bottom... |
Все товары поставщика
Похожие товары