L06S20 sewer pipe inspection tools
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
Fish Tape Fiberglass Wire Cable Running Rod |
The Reel Rod has a sturdy, powder coated, steel tube frame and features a 16" diameter storage basket. Up to 400 ft. of rod can be stored in this b... |
|
|
TC-500 Hand cable cutter |
TC-500 Max 500mm2 Hand Manual Cu/Al conductor Cable Wire Cutter The handle is made of high tensive aluminum alloy, the knives are made by forging, ... |
|
|
Equipment for the cable depot Cable-drum take-off rollers |
DP014-5: Rated Load-5T, apply for drum dia 600-2400mm, application of disc width-below 1600mm, shaft diameter-76mm, weight-95kg DP014-5: Rated Loa... |
|
|
FHC-42 cable cutting head |
Feature: 1.Flip top cutting head rotates 360 degree 2.New two stage hydraulic to reduce cutting cycle,automatic release pressure when cut is comple... |
|
|
NBN TRACE WIRE COPPER FIBREGLASS RODDER FISH SNAKE CABLE PULLER |
Purpose: Cable puller is mainly used for in building installation wiring duct drawing guide line, as well as the protection communication cable, po... |
供应产品
Same products
