preformed dead end grip for cables
Open weave hoisting grips provide an effective means for hoisting coax and elliptical waveguide into position and can be utilized to provide additional support once in place. The lace-up design allows the hoisting grip to be attached even when the run has been connectorized and facilitates easy positioning at 200 (61m) increments on long coax runs.
Closed weave hoisting grips feature a closed-mesh design which simplifies installation over traditional split, lace-up style grips. The unique design allows the pre-laced hoisting grip to slip over an unterminated end of coax. The grip securely tightens when pulled, providing an effective means to hoist coax into position and to provide additional support for the coax once in place.
Другие товары поставщика
|
|
cable winch, cable wire winch of guangtong001 |
The use of ground grinding security technology (1) the ground should be put on the flat, accessibility, and fixed tightly, prevent the ground plane... |
|
|
cable drumjacks with rotary disk |
Application Used to support wire reel when laying cable .Hold up the wire tray. Usage: for expanding the wire, the whole set of line on the six ... |
|
|
in bulk insulating rodder |
Technical Date of Fiberglass Duct Rodder Specification Rod Diameter (mm) Φ 4.5-Φ 16 Rod Length (m) 30m~500m Frame Spec. (mm) 1300x450x1330,... |
|
|
Bridge Roller Cable Laying roller Steel buried cable roller |
The cable roller can protect the cable, at the same time, cable block also can effectively reduce the friction of the cable, improve the constructi... |
|
|
Laying roller |
note: 1 Protect the conductor and pulling rope at wellhead bus-bar. 2 Leaning against the side of pithead directly while using. Used at the end of... |
Все товары поставщика
Похожие товары
