preformed dead end grip for cables
Open weave hoisting grips provide an effective means for hoisting coax and elliptical waveguide into position and can be utilized to provide additional support once in place. The lace-up design allows the hoisting grip to be attached even when the run has been connectorized and facilitates easy positioning at 200 (61m) increments on long coax runs.
Closed weave hoisting grips feature a closed-mesh design which simplifies installation over traditional split, lace-up style grips. The unique design allows the pre-laced hoisting grip to slip over an unterminated end of coax. The grip securely tightens when pulled, providing an effective means to hoist coax into position and to provide additional support for the coax once in place.
Other supplier products
|
|
portable shelves duct rod |
Fiberglass duct rodder is an auxiliary tool applied in towing lead-rope through a pipe. The rod surface is hard and smooth, so it can get through t... |
|
|
10mm x 490' Duct Rodder Fish Tape |
Outer protect layer are made of high density polyethylene engineering plastic, which has good anti-UV capability. Cover was coated with long-term U... |
|
|
Production equipment movable rodder |
Fiberglass duct rodder is an auxiliary tool applied in towing lead-rope through a pipe. The rod surface is hard and smooth, so it can get through t... |
|
|
SKG-7 bolt type wire rope clips |
Application: apply for anti-twist rope
Rated Load(KN)
Wire rope Diameter(mm)
Weight(Kg)
SKG-50N
50
11-15
7
SKG-70N
70
16... |
|
|
cable drum jacks |
Cable pulling and handling equipment: Hydraulic Cable Reel Stand 1. Used to support the cable drum. 2. Hydraulic lifting make it lift easily; 3. Ea... |
All supplier products
Same products
