L0750 push pull rodder
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Другие товары поставщика
|
|
AF-15 fish tape scraper |
A mechanical puller will severely damage the tape, and could lead to personal injury. Use a safe work position to avoid loss of balance when using ... |
|
|
CC-50B Cable Cutting Head fortelephone cables/armoured Cu/Alu cable |
Split hydraulic cable cutter can work with hydraulic hand pump or electric hydraulic pump, it is suit for big size of tele cables or armoured Cu/Al... |
|
|
BF-60 Customized frp push pull rodder |
A mechanical puller will severely damage the tape, and could lead to personal injury. Use a safe work position to avoid loss of balance when using ... |
|
|
Hand big Cable Wire Cutter TC-250 |
1.Strong, light weight glass fiber handle 2.Adjustable pivot bolt realized adjustable blade 3.Changeable,forging blade heat treated and precise pol... |
|
|
BS-30 new type eco duct rod |
The unique sloped handle optimizes the position of your hand for quick hand-over-hand rewinds and allows a more level payout of tape on the backswi... |
Все товары поставщика
Похожие товары
