L0750 push pull rodder
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
BF-15 duct rodderwith strengthen the core |
Flexible reinforce fiberglass core with polyethylene coating. professional electricians rely on brand! It is Light, Strong and Smooth with a steel ... |
|
|
Equipment for the cable depot Cable-drum take-off rollers |
Purpose: applicable to the line of the line construction in the development and release of the disc Features: the exhibition release speed is stabl... |
|
|
wholesale duct rodder |
Brand-New High Quality FibreGlass Duct Rodders or Snake Pullers can be used for NBN, Telecommunication, Electrician and other Department HDPE Pipe ... |
|
|
L0750T FRP snake rod for communication and construction |
1.Strong: maximum tensile damage coefficient under 700 kg (please don't exceed 700 kg, in order to avoid broken wire damage body), security departm... |
|
|
Cable pulley |
1 Protect the conductor and pulling rope at wellhead bus-bar. 2 Leaning against the side of pithead directly while using. Used at the end of the m... |
All supplier products
Same products
