L06S50 50M/6mm High strong Duct Rodders
Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Другие товары поставщика
|
Manual Cable Cutter TC-125S |
TC-125S cable cutter with telescopic handle,is forged, long life span and easy to cut. Feature: With telescopic handle. Attention:do not cut steel ... |
|
YQK-240 a new type of crimping pliers |
when using the surface pressure molding department not to rust, damage and dirt. Crimping pliers, if in the case of die residual metal debris still... |
|
BZ-65C/85C/105C electric Powered Cable Cutter |
1.a double piston pumpwhich is characterized by a rapid approach of the dies forwards the connector and a slow crimping motion. 2.which returns the... |
|
electric tools multihole cable drum jacks |
Application: for general outdoor underground cable Actinobacillus operation, high-altitude stringing House switchboard construction wiring. Operati... |
|
L06S50 Direct Marketing duct rodder |
1.Fish type with 7cm wire head,, the end of with a quick pulling wire. 2.Wires for counterclockwise direction of rotation 3.Plastic steel cable pul... |
Все товары поставщика
Похожие товары