L06S50 50M/6mm High strong Duct Rodders
Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
independent producer eco duct rodder |
Polyethylene cover: Medium density polyethylene resin for the insulating and jacketing of cables.Rolling bearing cage flotation (reel transport) fo... |
|
|
factory Cable Guide manufacture Aluminium Roller |
1.Application: Used for guiding cable to turn and set free. and used for setting power cable and communication cable in trenchers or on ground. 2.... |
|
|
HZ-85 Safety Hydraulic Cable Cutter |
1. Flip top cutting head rotates 350o 2.Two stage hydraulic to reduce cutting cycle, automatic release pressure when cut is completly stop 3. Manua... |
|
|
T2 good for sewer duct rodder/ quick pulling |
1.Black spring and red glue to the above 2.Wire rope twists the figure 8 3.Wire wear into the figure 8, spring lock wire 4.Wire put into red rubber... |
|
|
AF-15 fish tape scraper |
A mechanical puller will severely damage the tape, and could lead to personal injury. Use a safe work position to avoid loss of balance when using ... |
供应产品
Same products
