Heat Bed MK2B Red
Heat Bed MK2B RedThis heatbed is designed to be compatible with any 3D printer that can accept the RAMPS MK2B version of heatbed. This heatbed has a dual power capability allowing it to be used with 12V or 24V power supply sources. It features a central mounting hole on the front side to allow for three point mounting. This is much easier for bed leveling in comparison to 4 point mounting. First level the side with two holes and fix in place, then level the side with one hole. A glass plate is highly recommended to provide a truly flat surface and rigidity. Additionally, the solder pads have been greatly increased in size, making it much easier and allowing for the use of 1206 surface mount components. But this does not remove the need to use proper strain relief. Features: Come with resistor and LEDs soldered, basic soldering skills needed to solder the power wire Dimensions (Outer): 214mm x 214mm Dimensions (Heat Bed): 200mm x 200mm Laminate FR4 1.6¡À0.15mm 2 Layer, 35¦Ìm Copper Power Input: 12V / 24V DC Copper Plated Holes Very good in combination with RUMBA or Taurino Power
Другие товары поставщика
|
|
|
Product Overview:HC-SR505 small body sensing module is based on infrared technology, automatic control products, high sensitivity, high reliability... |
|
|
|
4in1 700 Point SYB-500 Tiepoint PCB Solderless BreadboardFeatures: •SYB-500 Breadboard 4 in 1 4 X SYB-118 700 Positions Tiepoint PCB Solderless Uni... |
|
|
|
Product DescriptionManufactured By Atomic Market Gas Detection MQ135 Control Main Chip: LM393 Operating voltage: DC 5V Dual signal output |
|
|
|
STC Minimum System Board Development Board 51 MCU Development BoardProduct DescriptionName: Minimum system board development board1, 40 pins all th... |
|
|
|
GY-511 LSM303DLHC e-Compass 3 Axis Accelerometer Magnetometer Module SensorModel: GY-511Material Copper-clad plateFeatures: Chipset LSM303DLHCSpec... |
Все товары поставщика
Похожие товары
