Heat Bed MK2B Red
Heat Bed MK2B RedThis heatbed is designed to be compatible with any 3D printer that can accept the RAMPS MK2B version of heatbed. This heatbed has a dual power capability allowing it to be used with 12V or 24V power supply sources. It features a central mounting hole on the front side to allow for three point mounting. This is much easier for bed leveling in comparison to 4 point mounting. First level the side with two holes and fix in place, then level the side with one hole. A glass plate is highly recommended to provide a truly flat surface and rigidity. Additionally, the solder pads have been greatly increased in size, making it much easier and allowing for the use of 1206 surface mount components. But this does not remove the need to use proper strain relief. Features: Come with resistor and LEDs soldered, basic soldering skills needed to solder the power wire Dimensions (Outer): 214mm x 214mm Dimensions (Heat Bed): 200mm x 200mm Laminate FR4 1.6¡À0.15mm 2 Layer, 35¦Ìm Copper Power Input: 12V / 24V DC Copper Plated Holes Very good in combination with RUMBA or Taurino Power
Other supplier products
|
|
|
Mechanical Endstop B (with cable)The mechanical endstop uses a lever switch to detect when it is activated. The switch is wired up so that when act... |
|
|
|
Product Description3.5-5.5V Active Standard Passive Buzzer Module For Arduino Specification: Working voltage: 3.5-5.5V Working current: PCB Dimensi... |
|
|
|
ESP8266 Serial ESP-08 WIFI Wireless Transceiver ModuleDescription:ESP8266 Serial ESP-08 WIFI Module WIFI Coexistence Module Wireless Transceiver Mo... |
|
|
|
Features：Relay contact capacity:10A250VHas optocoupler protectionDrive voltage:5V or 3.3VOnboard power supply module does not need an external powe... |
|
|
|
3M Patch Lan Cable RJ45 Ethernet Internet Network 3 Meters CAT5 Network Cable for Raspberry PI 2 and Banana PiFEATURES:USE: The product is used to ... |
供应产品
Same products
