Smoke Detector 4-wire with relay output DC powered
4-Wire Smoke Detector with Relay output DC powered YT-142 The detectors are photo-electronic detector uses a state of-the-art optical sensing chamber. This detector is designed to provide open area protection and to be used with most security alarm control panel. Two LEDs on each detector provide local 360° visible alarm indication. They flash every six seconds indicating that power is applied and the detector is working properly. The LEDs latch on in alarm. LEDs will be off when a trouble condition exists indicating that the detector sensitivity is outside the listed limit. The alarm can be reset only by a momentary power interruption. The detector that initiated the alarm condition will have its red LED and relays latched until reset by panel. The default condition for the relay is normally open (NO). It can be adjusted to Normal close (NC) condition. 2. SPECIFICATIONS Operating Voltage Range: 9 to 28 VDC Volts Non-polarized Standby Current: ≤200μA Maximum Alarm Current (LED on): ≤45mA Alarm Relay Contact Ratings: 2A@ 24V DC Operating Humidity Range: ≤95%RH(40°C±2°C) Relative Humidity, Non-condensing Operating Temperature Range: -10°C to 50°C (14°F to 122°F) Smoke Alarm Sensitivity: 1.06±.26%FT Temperature Alarm Sensitivity: 57°C (135°F) A1R (only for with heat sensor) Height: 55 mm installed in Base Diameter: 103 mm
Other supplier products
|
Safety Home Wireless Break Beam System anti theft |
Active photoelectric infrared grating for window break in prevention. Detection distance within 10m outdoor intrusion detector. It is updated wirel... |
|
Home Alarm Systems |
LCD display 32 wireless 8 wired PSTN network Ademco 4+2 contact id alarm systems. The control panel can report detailed alarm information such as a... |
|
Cooperate with Security Service, Alarm Installers |
We provide specified hotel security solution, school security solution, community alarm solution, bank surveillance guard solution. Alarm installat... |
|
CO detector Carbon Monoxide Alarm AC or DC power NC NO output |
Toxic gas detector and gas alarm of environment security sensor. CO303 AC power wire in or plug in type or CO343A DC9-28VDC power relay NC or NO ou... |
|
|
MN/300/100 fire alarm control panel Overview The MN300 is a new type of analog fire alarm control panel which has 100 alarm control points (detecto... |
All supplier products
Same products