repair kits
1.Drilling:
1.Drill out the damaged threads using the proper drill, drill to a sufficient depth to accommodate the CL-COIl insert length and the bolt or screw being used.
2.Tapping:
Drilled holes to be tapped with our taps for the corresponding size of insert to be installed.
3. installation:
Place the inset on installation tool, positon the adjustable ring, so that the insert tang is in center of tang slot.
Place the installation tool over the hole and wind the insert into the hole until the top coil is 1/2 turn below the top surface.
4. Removal the tang
To blow-off the Tang after fitment of Inserts by tang break tools, give a sharp blow to remove the tang; the bolt can go through and through. Due to the narrow and exact tolerance the new thread normally is stronger than original one.
Other supplier products
|
|
M6*1 wire thread repair kit |
1. Helical Kit include 25 wire thread inserts, one tap, one inserting tool, one drill, one tang break off punch.
2. Strengthen the internal thread... |
|
|
self tapping thread insert |
Stainless steel helical metal fasteners
No.1. helical metal fasteners introduction
Helical metal fasteners Inserts (also known as self ... |
|
|
Machine insert |
Machine Inserts Tooling with 1/4'' hexagonal drive and depth stop |
|
|
tangless insert |
"Tangless insert" is also called "no mounting shank thread insert" and is a kind of wire thread insert.
No mounting shank wire thread inserts have... |
|
|
307 M10*1.75 Self-Tapping Inserts With Three Cutting Bores 12mm |
Features:
1. Self tapping
2. no pre-tapping required
3. Very high pull-out resistance
4. Highly resistant to vibration, can withsta... |
All supplier products
Same products
