Marine Separator Unit
The product is mainly used to remove water and mechanical impurities from diesel, fuel oil, lubricating oil and other mineral oil in Marine diesel engine and land-used diesel generating sets of power station so as to reduce wear of the piston and cylinder liner for diesel engine and to avoid high-pressure pump bite of nozzle blockage hair and fault, which will prolong service life. Also used to separate two unsolvable liquid with different specific gravity or remove small amount of solid particle form liquid.
This unit has high thermal efficiency, compact structure, beautiful appearance, easy installation and maintenance, there are low pressure alarm functions, oil temperature remote alarm functions, with motor overloaded alarm and conventional fault alarm. The separator unit adopts automatic control. It has the advantages of high efficiency, low oil consumption, convenient operation and economic maintenance cost.
The separator unit is composed of separator, primary fuel filter, fuel oil heater, oil supply pumps, temperature sensors, control box, base, instrument, valves, piping attachments, and so on.
The oil product of settling tank was enter the inlet of separator supply unit, by primary filter, oil product is supplied to heater by supply pumps, after heating to the separation temperature, Enters separator, the heating temperature is controlled by temperature control system. The clean oil after separating is sent to the daily oil tank.
Send product request
Other supplier products
 |
Electric Heating Calorifier | The electric heating calorifier can be installed on ship, which has the power source of AC 3P/380V/50Hz or AC 3P/440V/60Hz. It can supply the hot w... |
 |
Dry Spark Arrester Silencers | The dry spark arrester silencers is suitablefor most of diesel engine to eliminate the spark and lower the noise. It is widely used in tanker, pas... |
 |
Sewage Treatment Plant | The plant is applicable to treat the sewage from the onboard ship toilets to meet MEPC159（55）international standards of discharge. The Sequencing ... |
 |
Steam Heating Calorifier | The steam heating calorifier can be installed on ship, which has the power source of steam. It can supply the hot water for crewmen |
 |
Oil Strainers | This product is suitable for working temperature not higher than 80℃for FO. and LO. piping. |
