Low cost Four slots charging bracket walking rack gear cooling bed
It is a cooling equipment that used for cooling of hot small section rod or simple profile steel by air flow or forced ventilation. Suitable for rolling speed is ≤ 16 m/s wire rod or bar double piece rolling mill, sizes are 8-36 mm; manufacture cost is low;
Main composition: four slot bracket charging device/straightening plates/walking rack conveyor/aligning roller table/collecting bench /output roller table .
Other supplier products
|
|
coil collecting station for high speed wire rod(HSWR) |
Be used for loosen coil collecting of high speed wire rod. It consists of: coil collecting drum, binary mandril, coil lifting platform,coil transfe... |
|
|
Simple structure reliable D600 Disk dividing Flying shear |
Disk dividing flying shear has simple structure, reliable operation, installation and use onvenient.It is widely used dividing cutting of bar rolli... |
|
|
Control valve station for rolling mill hydraulic system |
BE Used for rolling mill hydraulic system control circuit.main composition: hydraulic control valve, piping, steel frame, etc. |
|
|
High control accuracy energy saving Mill AC frequency conversion control cabinet |
The AC frequency conversion motor drive adopts Siemens, ABB, Schneider and other international brands of inverter as a core component, with charact... |
|
|
600 550 520 450 400 365 325 280 two gear shaft distributer/box |
This is corollary equipment for two-high openable housing rolling mill, with one input shaft and two output shaft, speed ratio 1:1, it consists of ... |
All supplier products
Same products
