Low cost Four slots charging bracket walking rack gear cooling bed
It is a cooling equipment that used for cooling of hot small section rod or simple profile steel by air flow or forced ventilation. Suitable for rolling speed is ≤ 16 m/s wire rod or bar double piece rolling mill, sizes are 8-36 mm; manufacture cost is low;
Main composition: four slot bracket charging device/straightening plates/walking rack conveyor/aligning roller table/collecting bench /output roller table .
在线联系供应商
Other supplier products
 |
250/630 Lubrication Oil station system for rolling mill gear reducer | 250 Lubrication system Be used for rolling mill reducer lubrication. Main composition: tank/pump/filter/cooler/motor; Model: XYZ - 250L, nominal fl... |
 |
Four-strand Pinch roll for ordinary wire rod | It is used for The cooling bed entrance for ordinary double rolling bar production line. It consistes of steel plate welding housing, four pairs of... |
 |
630 550 520 450 400 365 three gear shaft distributer/box | This is corollary equipment for three-high openable housing rolling mill, with one input shaft and two output shaft, speed ratio 1:1, it consists o... |
 |
365-630 three high openable housing top and bottom adjusting mill | The openable mill housing consistes of casting mill housing frame and casting cover with top adjusting mechanism, tie rod, lock parts, this mill ho... |
 |
Hydraulic station for cooling bed transfer car of bar production line | BE Used for rolling mill hydraulic system power circuit.main composition: hydraulic pump, filter, cooler, motor, pipes, tanks, etc |
