Waste water treatment by air oxidation
Wet catalytic oxidation, the standard abbreviation CWO, refers to raising the temperature of wastewater to 180 ℃ - 325 ℃, using the oxygen in the air to increase the solubility with the increase of pressure. Under the action of catalyst, oxygen molecules and organics in wastewater undergo a rapid oxidation reaction, resulting in ring breaking and chain breaking of organics, which are collectively referred to as degradation.
The principle of degradation reaction is free radical chain reaction. The primary products of oxidative degradation are simple organic acids and organic alcohols below C4. Some of the degradation products will be deeply degraded and mineralized into carbon dioxide to form the removal of TOC. The degradation rule is that the higher the reaction temperature is, the greater the proportion of deep degradation to carbon dioxide is.The catalytic strength can reduce the energy level of degradation reaction and increase the speed of degradation reaction. The top of wet catalytic oxidation process is supercritical oxidation.
Medium temperature and medium pressure wet catalytic oxidation is a kind of wet catalytic oxidation. It refers to the process of wet catalytic air oxidation in the temperature range of 180 ℃ - 258 ℃ and the corresponding pressure range of 2.5mpa-5.0mpa.
A large number of engineering practices have proved that: wet catalytic oxidation in the middle temperature and middle pressure section can obtain good degradation effect and appropriate COD removal effect, supplemented by other low-cost sewage degradation means, can obtain the best economy (investment, operation, life).
Technical Featuresof
- The maximum inlet temperature of medium temperature and medium pressure system shall not exceed 258 ℃, and the maximum operating pressure shall not exceed 5.0mpa. The pressure control is very stable, the service life of the equipment is long, and the failure rate is low.
- Under the operation condition of medium temperature and medium pressure system, the system has relatively small supplementary heat and low pressure, and the operation power consumption of air compressor is low. The main operating cost of wet oxygen process comes from air compressor and hot oil furnace. Therefore, the operating cost of medium temperature and medium pressure system is generally reduced by about 50% compared with that of high temperature and high pressure wet oxygen system.
- The system adopts our unique long-term fixed bed catalysis, namely heterogeneous catalysis system. Its advantage is that no heavy metal ions (commonly used homogeneous catalytic materials) are added into the tower materials to avoid secondary pollution caused by heavy metals and reduce the cost of operation catalysis.
More information please via:
Send product request
Other supplier products
 |
SL TEC Formaldehyde Plant | SL TEC has close to ten years experience in based on silver contact process(or silver catalyzed process). A lower methanol consumption, higher for... |
 |
Hydrogen Peroxide Manufacturing Plant | There are several methods for, among them theAO(auto-oxidation) processis the most prevailing one. In this process, 2-alkyl anthraquinone is mixed... |
 |
Acrylic Impact Resistant Modifier | is mainly used to improve the impact properties and processability of PVC. PVC is important among general plastics. It has high strength, low pri... |
 |
UHMWPE Plant | Ultra high molecular weight polyethylene (hereinafter called as UHMWPE) is a linear structural polyethylene (PE) with viscosity-average molecular w... |
 |
PPC Plant | is acompletely biodegradable environment-friendly plastic synthesized from carbon dioxide and propylene oxide. Besides, due to its using the main... |
Same products
 |
XD-MAX Winch for Drone | Seller: NEW WING ADVANCED (TIANJIN) TECHNOLOGY CO., LTD | XD-MAX Winch for Drone The XD-MAX Winch for Droneis a high-performance aerial lifting solution d... |
 |
XD-55 Winch for Drone | Seller: NEW WING ADVANCED (TIANJIN) TECHNOLOGY CO., LTD | XD-55 Winch for Drone Introducing the XD-55 Winch for Drone—an advanced lifting system eng... |
 |
XD-10 Winch for Drone | Seller: NEW WING ADVANCED (TIANJIN) TECHNOLOGY CO., LTD | XD-10 Winch for Drone SAFE, EFFICIENT AND CONVENIENT.Your reliable and intelligent air transport... |
 |
Uratech ER16 Collet Rack – CNC Collet Storage for ER, DR & RD 16 Series | Seller: Uratech USA Inc | TheUratech ER16 collet rackis a premium storage solution designed for CNC shops, toolrooms, and m... |
 |
Uratech Tool scoot cart for 50 taper tool holders | Seller: Uratech USA Inc | Maximize efficiency in your machining operations with our50 taper CNC tool carts, the ultimate so... |
