Micro needle Products- Third Party Inspection 100% Quality Control
At the beginning of production, our inspectors will check on the quality of main components, material and accessories according to clients’ specifications and/or reference sample. The IPI thus permits timely corrections and improvements before the mass production is initiated；any non-conformity is immediately reported so as to avoid delay in shipment.
The main aspects checked for IPI:
·Evaluate the production capability and equipments in the factory
·Check factory’s quality control ability and executive status
·Check the accuracy of production facilities and equipments
·Audit production techniques and make sure the reasonable layout of factory QC person
·Check the quantity and quality of raw material and main components that will be used in the products, foreseeing any possible problems and avoid them, verifying that the product specifications are being met early.
Send product request
Other supplier products
 |
Hourglass inspection service quality QC on-site inspection | $150USD All inclusiveanywhere in China for 1 Manday Inspection. 2. Service Introduction : Whether you are developing products, projects, or proce... |
 |
Tent inspection services and quality control of Guangdong Huajian Inspection Co., Ltd | HQC Inspection service provide thorough and detailed quality check in China of products, Our Quality Controls include : QuantityIntegrityDimension... |
 |
Pre-shipment kitchenware product inspection service for Chinese third-party products | According to the clients' requirements, during production time, we fully check the quality of semi-finished and finished products and also find out... |
 |
Puzzles inspection services and quality control of Guangdong Huajian Inspection Co., Ltd | Glory Benefit Inspection Service will inspect raw materials and components before production begins. After the client provides product samples, we ... |
 |
Kitten toys inspection services and quality control of Guangdong Huajian Inspection Co., Ltd | This check is conducted during the very early stages of the production process (between 0 and 20%). The purpose of the check is to inspect the proc... |
