Micro needle Products- Third Party Inspection 100% Quality Control
At the beginning of production, our inspectors will check on the quality of main components, material and accessories according to clients’ specifications and/or reference sample. The IPI thus permits timely corrections and improvements before the mass production is initiated；any non-conformity is immediately reported so as to avoid delay in shipment.
The main aspects checked for IPI:
·Evaluate the production capability and equipments in the factory
·Check factory’s quality control ability and executive status
·Check the accuracy of production facilities and equipments
·Audit production techniques and make sure the reasonable layout of factory QC person
·Check the quantity and quality of raw material and main components that will be used in the products, foreseeing any possible problems and avoid them, verifying that the product specifications are being met early.
在线联系供应商
Other supplier products
 |
Mini plane toys Products- Third Party Inspection 100% Quality Control | This check is conducted during the very early stages of the production process (between 0 and 20%). The purpose of the check is to inspect the proc... |
 |
Pre-shipment Wooden artcraft inspection service for Chinese third-party products | The pre-shipment Inspection takes place when the merchandise is 100% completed, and at least 80% of the products are packed, marked. Our inspectors... |
 |
Pre-shipment Pizza spatula inspection service for Chinese third-party products | The DUPRO provides the on-line inspection, DQC qualified inspectors will check that the corrections and improvements suggested during the IPC were ... |
 |
Pre-shipment Roof tile inspection service for Chinese third-party products | $150USD All inclusiveanywhere in China for 1 Manday Inspection. 2. Service Introduction : Whether you are developing products, projects, or proce... |
 |
Chinese plastic plate inspection services/ quality control in China | $150USD All inclusiveanywhere in China for 1 Manday Inspection. 2. Service Introduction : Whether you are developing products, projects, or proce... |
