Oil Pump Vane
Brief introduction of oil pump vaneOil pump vane is made of bearing steel Gcr15(AISI 52100), we cut the steel sheet to little plates by laser. Then do the spheroidizing, heat treatment and grind the radius by diamond hubbing cutter. Material compositionCSiMnPSCrNiMoWV0.990.250.350.0210.021.510.02PbNbSnAsSbBiN[O][N][H]×10-4×10-4×10-4×10-4 Hardness: HRC 60-64Perpendicularity: 0.01 mmParallelism: 0.02 mmRoughness: Ra 0.4 Quality control of oil pump vane:Work instruction paper and pictures at each working positionProcess flow card with each tray (Fully traceability)Sampling inspection and routing inspectionTS:16949 5 tools: PPAP, APQP, FMEA, SPC, MSAMaterial composition certificateDimensional report as per your requirement by CMM, projector, etc
Other supplier products
|
|
|
Shock absorber rod guide is made by powder pressing and sintering (Powder Metallurgy) technology.Some types will be inserted red PTFE DP4 sliding b... |
|
|
|
We produce various types of connecting rod, piston, valve plate for piston compressor in household air conditioner, car air conditioner and refrig... |
|
|
|
We produce various types of connecting rod, piston, valve plate for piston compressor in household air conditioner, car air conditioner and refrige... |
|
|
|
Sintered bearing, also named oil impregnated bearing, is made by powder metallurgy technology, which is pressed by the mould and do sintering, coin... |
|
|
|
Shock absorber signal wheel is made by powder pressing and sintering (Powder Metallurgy) technology, then do black steam oxidation as per surface t... |
供应产品
Same products
