Automatic and hydraulic uncoiler with coil car
Uncoilers or Decoiler
It is Automatic and hydraulic, can be used to uncoil steel coil which is maximal 1300mm’s wide, no more than 12 ton’s weighty and steel coiler’s inner diameter is about 500 or 600mm.
De-coiler and coiler car for steel sheet
The Hydraulic De-coiler is used to hold and drive the steel coil that is being fed into the roll forming machine. The de-coiler allows for a quick change of steel coli with minimal manual labor. The de-coiler is powered with a feedback system that ensures the roll former is not required to turn the coil. The de-coiler will turn as required to reduce the potential for over coiling.
Maximum coil mass: 12,000 kg
Nominal coil ID: 500mm supplied with addition spaces to use 600mm above
Maximum coil OD: 1300mm
Maximum coil width: 1300mm
Machine consists of the following major items:
Machine frame
Overhung shaft with roller bearing
Drive motor and chain
Hydraulic power pack (shared power pack on top /bottom coil)
Hydraulic cylinder of expansion/retraction
Solenoid valves
Electrical control system
Limit system to allow positioning of de-coiler for different feed positions. Manual positioning with position indicator.
Coiler Car-Powered loading bed to aid in loading to the de-coiler.
Other supplier products
|
|
Preheating room using infared heater heating |
Individually controlled top and bottom steel pre-heaters heat the steel to the correct temperature prior to the application of the polyurethane. Th... |
|
|
PUR, PIR (Polyurethane)， Rock wool,mineral wool,glass wool Sandwich Panel Product Line |
PUR, PIR (Polyurethane)，Rock wool Sandwich Panel Product Line could automatically make PUR,PIR,rock wool,mineral wool,glasswool sandwich panel for ... |
|
|
PUR/PIR /Polyurethane sandwich panel product line |
PUR, PIR (Polyurethane) sandwich panel product line continuous make the PUR,PIR sandwich panel with the thickness 50mm-200mm.The main composing of ... |
|
|
Roof roll forming machine with hydraulic profile cutter |
Roof roll forming machine could make roof profile steel sheet. It could be used independently or used in whole sandwich panel line. The main compos... |
|
|
Wall roll forming machine with hydraulic profile cutter |
Wall roll forming machine could make wall profile steel sheet. It could be used independently or used in whole sandwich panel line. Edge Joint Roll... |
供应产品
Same products
