T2 quick cable tight , storage box
1.Made of steel wire rope
2.Density: 8(g/m)
3.Rod diameter 2(mm)
4.Temperature - 800 to 800 (℃)
5.Traction tension failure 800(kg)
Operation:
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
|
hand grinder, lifting and traction |
It mainly consists of two motor, one reduction box traction head and up frame, etc. It not only applied for traction power cable, communication cab... |
|
|
W0830 Good Rigidity Duct Rodder |
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secon... |
|
|
CPC-65C/85C/105C/120C Hydraulic Wire CableCutting Head |
CPC-65C/85C/105C/120C Hydraulic Wire Cable Cutting Head 1.Opening C type cutting head 2.Hydraulic quick couper connect with the pump for working 3.... |
|
|
FHT-300/400G split type hydraulic clamp crimping tool |
Hydraulic crimping pliers:Monolithic crimping pliers, crimping pliers need to separate with the corresponding pump, general suitable for electric o... |
|
|
New type Cable End Strippers SNAP Power Driven Stripper |
Application 1.tungsten steel blade,hard and sharp. 2.Can cut the smooth degree of slope. 3.For cutting out the standard of thick wide angle,diamet... |
供应产品
Same products