T50 Electricians Puller Rods Wires Draw Push Pulling
1.Made of steel wire rope
2.Density: 8(g/m)
3.Rod diameter 2(mm)
4.Temperature - 800 to 800 (℃)
5.Traction tension failure 800(kg)
Operation:
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
|
Manual Cable Cutter TC-500 |
TC-500 Max 500mm2 Hand Manual Cu/Al conductor Cable Wire Cutter The handle is made of high tensive aluminum alloy, the knives are made by forging, ... |
|
|
EZ-85 electric powered cable cutter function |
Cutting force: 60KN Stroke: 86mm Cutting cycle: 70 times Cutting range: dia 85mm (Cu/Al cable and armoured cable) Voltage: 18v Capacity: 3.0Ah Char... |
|
|
Fish Tape Fiberglass Wire Cable Running Rod L0415 |
Purpose: Cable puller is mainly used for in building installation wiring duct drawing guide line, as well as the protection communication cable, po... |
|
|
wire mesh grips |
Cable Grips are a quick, efficient way to install/control electrical or heavy-duty cables. Cable Grips are re-usable (subject to inspection) and ca... |
|
|
BF-30 CBRL duct rodder |
Features: 1) Strong non-conductive fiberglass rod construction. 2) Rustproof bull-nose pulling eye. 3) For longer conduit runs and underground duct... |
供应产品
Same products