T30 quick pulling wire
1.Made of steel wire rope
2.Density: 8(g/m)
3.Rod diameter 2(mm)
4.Temperature - 800 to 800 (℃)
5.Traction tension failure 800(kg)
Operation:
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
|
China Powered Winches, best factory Cable Winch,ENGINE WINCH |
It mainly consists of two motor, one reduction box traction head and up frame, etc. It not only applied for traction power cable, communication cab... |
|
|
cable dispenser truckle |
DP014-5: Rated Load-5T, apply for drum dia 600-2400mm, application of disc width-below 1600mm, shaft diameter-76mm, weight-95kg DP014-5: Rated Loa... |
|
|
Stripping Tools for Insulating layer |
1.Quick & easy maneuverability. 2.Easily opens/separates the steel tape armor on fiber optic cable 3.Blade rotates 90 by activating blade lever... |
|
|
Stripper for high voltage cable |
1.tungsten steel blade,hard and sharp. 2.Can cut the smooth degree of slope. 3.For cutting out the standard of thick wide angle,diameter of the cab... |
|
|
Cable roller SH450 |
note: 1 Protect the conductor and pulling rope at wellhead bus-bar. 2 Leaning against the side of pithead directly while using. Used at the end of... |
供应产品
Same products