Split Ring Grips Fiber Optic Pulling Grips supplier
Open weave hoisting grips provide an effective means for hoisting coax and elliptical waveguide into position and can be utilized to provide additional support once in place. The lace-up design allows the hoisting grip to be attached even when the run has been connectorized and facilitates easy positioning at 200 (61m) increments on long coax runs.
Other supplier products
|
|
REC-5510 Plug-in crimping plier from Japan |
1 The head can rotate 360, two-speed double-acting hydraulic equipment by design 2 When the pressure to complete stop of the motor and automaticall... |
|
|
sewer insulating rodder |
The outside layer is smooth and firm ABS resin. It is widely used for the cables works or cleaning in cable pipe or channels. It has the advantages... |
|
|
Cable pulling Grips |
mainly used for all kinds of wire and cable (overhead conductors, insulated cables, etc.) of tractor pay-off construction, is the electric power (o... |
|
|
BZ-65C/85C/105C power cutter for cable |
allows the user to return the piston into the starting position in case of an incorrect crimp. The unit is equipped with a special brake when stops... |
|
|
L06S30 Customized push pull rodder |
Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe line... |
供应产品
Same products