T30 ELECTRICIANS PULLER RODS WIRES
1.Made of steel wire rope
2.Density: 8(g/m)
3.Rod diameter 2(mm)
4.Temperature - 800 to 800 (℃)
5.Traction tension failure 800(kg)
Operation:
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
Heavy Duty Cable Roller manufacture |
1.Application: Used for guiding cable to turn and set free. and used for setting power cable and communication cable in trenchers or on ground. 2.... |
|
BS-15 high strength cobra duct rod |
Note: keep one hand holding the interior wall of Wire device while use it, and the other hand holding the handle of wire device, rotating clockwise... |
|
SKL-6 straining wire grip |
Wire clamping device is the power, telecommunications, railway electrification overhead line construction and maintenance of the commonly used to h... |
|
L0420 fiberglass push pull rod for NBN telcom fish tape |
The intensity of traction, flexibility, anti-aging, heat resistance, resistance to acid and alkali degree are considerably more than 1 or 2 generat... |
|
Cable roller DPHC01 |
The cable roller can protect the cable, at the same time, cable block also can effectively reduce the friction of the cable, improve the constructi... |
供应产品
Same products