cable pulling socks
Cable Grips are a quick, efficient way to install/control electrical or heavy-duty cables. Cable Grips are re-usable (subject to inspection) and can also be used to support or pull any cylindrical object within their grip and load carrying capacity.
These Grip offer a flexible eye and double weave stainless steel wire construction for regual load pulls.Always read Breaking Strength,safety and technical data informatin. The approx mesh lengthis measured at an average grip diameter.
Open weave hoisting grips provide an effective means for hoisting coax and elliptical waveguide into position and can be utilized to provide additional support once in place. The lace-up design allows the hoisting grip to be attached even when the run has been connectorized and facilitates easy positioning at 200 (61m) increments on long coax runs.
Other supplier products
|
|
cash on delivery movable rodder |
Fiberglass duct rodder is an auxiliary tool applied in towing lead-rope through a pipe. The rod surface is hard and smooth, so it can get through t... |
|
|
cable drumjacks with rotary disk |
Application Used to support wire reel when laying cable .Hold up the wire tray. Usage: for expanding the wire, the whole set of line on the six ... |
|
|
SKD35-50 earth wire grip,earth cable grip,steel strand cable grip |
Suitable conductor（GJ）
Rated Load（KN）
Maximum Opening（mm）
Weight（kg）
SKD35-50
25-70
20
10
SKD70-100
95-120
30
14
... |
|
|
exportation movable rodder |
Technical Date of Fiberglass Duct Rodder Specification Rod Diameter (mm) Φ 4.5-Φ 16 Rod Length (m) 30m~500m Frame Spec. (mm) 1300x450x1330,... |
|
|
tracing duct rodder |
Features Constructed of fiberglass reinforced in the center and consists of a rugged plastic layer that would ensure the lifetime of the flexible r... |
供应产品
Same products
