T30 quick pulling wire
Operation:
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
|
Ladder cable rack |
Cable jacks according to usage is also referred to as the cable bracket, wire shaft disc rack, cable bracket. The form can be divided into, hydraul... |
|
|
L06S30 Customized push pull rodder |
Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe line... |
|
|
L06S30 plastic steel cobra duct rod |
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secon... |
|
|
CYO-410 copper aluminum nose pick up |
Hydraulic crimping pliers:Monolithic crimping pliers, crimping pliers need to separate with the corresponding pump, general suitable for electric o... |
|
|
cable stripper for cable insulation layer |
1.Quick & easy maneuverability. 2.Easily opens/separates the steel tape armor on fiber optic cable 3.Blade rotates 90 by activating blade lever... |
供应产品
Same products