T50 quick cable tight 50m with sleeve
Operation:
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
|
HT-131H open type hydraulic pliers |
according to the frequency of daily use, crimping pliers, pin, shaft and bearing contact surfaces should be timely daub lubricating oil; Crimping p... |
|
|
exportation insulating rodder |
Constructed of fiberglass reinforced in the center and consists of a rugged plastic layer that would ensure the lifetime of the flexible rod. Assem... |
|
|
L06S30 Customized push pull rodder |
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secon... |
|
|
Nylon Pulley for cable belt nylon roller |
Electrical cable roller is a equipment for laying,pulling,guiding and protecting cable/rope/wire,which is a great way to save time and money. It is... |
|
|
THC-45 Rotates 360 Hydraulic Cable Cutter |
Item No: THC-45 Cutting force: 60KN Cutting range: dia 45mm Cu/Alu cable and Armoured Cu/Alu cable. Stroke: 50mm Length: 560mm Weight: 4.80kg Packa... |
供应产品
Same products