T2 wholesale quick pulling wire
Operation:
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
|
cable stand with Horizontal release frame |
DP028-2: rated load 2T, thickness of bottom plate-6mm, dia of bottom plate-800mm, weight- 50kg DP028-3: rated load 3T, thickness of bottom plate-6... |
|
|
T30 quick pulling wire 30m with sleeve |
1.Made of steel wire rope 2.Density: 8(g/m) 3.Rod diameter 2(mm) 4.Temperature - 800 to 800 (℃) 5.Traction tension failure 800(kg) |
|
|
NNEP eco duct rodder |
A braided wrap of reinforcing fibers increases its rigidity and helps bond the core with the outer plastic coating. The coating is made from a poly... |
|
|
HZ-45 Hydraulic Hand Armoured cable cutter |
hydraulic cable cutter Cutting range:DIA.45mm Cu/Alu cable and Amoured Cu/Alu cable Flip top cutting head rotates 350°. Two stage hydraulic to ... |
|
|
large multihole cable jacks |
Cable pulling and handling equipment: Hydraulic Cable Reel Stand 1. Used to support the cable drum. 2. Hydraulic lifting make it lift easily; 3. Ea... |
供应产品
Same products