T2 quick tight with wire steel rope
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
|
BS-30 new type eco duct rod |
The unique sloped handle optimizes the position of your hand for quick hand-over-hand rewinds and allows a more level payout of tape on the backswi... |
|
|
stainless steel cable socks |
Open weave hoisting grips provide an effective means for hoisting coax and elliptical waveguide into position and can be utilized to provide additi... |
|
|
iberglass Cable Guide Roller |
Constructed of fiberglass reinforced in the center and consists of a rugged plastic layer that would ensure the lifetime of the flexible rod. Assem... |
|
|
T30 quick pulling with 100ft storage box |
1.Black spring and red glue to the above 2.Wire rope twists the figure 8 3.Wire wear into the figure 8, spring lock wire 4.Wire put into red rubber... |
|
|
FLEXI LEADER FOR FIBREGLASS RODDER |
Medium strength, medium flexibility, and good abrasion resistance. Used in garage doors, winches, and tie down applications. Not intended for use i... |
供应产品
Same products